A) PE2 pushes one label on the IP packet and forwards it to ASBR2.
B) ASBR2 forwards the IP packet with one label to ASBR1.
C) ASBR1 forwards the IP packet with two labels to PE1.
D) PE1 forwards an unlabeled IP packet to CE1.
Correct Answer
verified
Multiple Choice
A) The lower the age-time, the higher the probability of flooding of unknown traffic.
B) The higher the age-time, the higher the probability of flooding of unknown traffic.
C) The local and remote age timers are, by default, the same value.
D) There is no relationship between the age-timers and the probability of flooding of unknown traffic.
Correct Answer
verified
Multiple Choice
A) H-VPLS
B) IEEE 802.1ag
C) MAC aggregation
D) MAC-in-MAC
Correct Answer
verified
Multiple Choice
A) Configuring labeled eBGP sessions between CSC-CE and CSC-PE routers.
B) Configuring a policy on each CSC-CE to advertise local PE addresses to the network provider.
C) Configuring labeled iBGP sessions between PEs residing in different customer carrier sites.
D) Advertising the received system addresses of remote PEs using either iBGP or IGP/LDP within each customer carrier site.
Correct Answer
verified
Multiple Choice
A) Queue 3, because it is explicitly defined in the SAP-egress policy.
B) Queue 2, because it is explicitly configured in the queue-group template.
C) The default, queue 1, because there is a mismatch between the mapping in the SAP-egress policy and in the queue-group template.
D) AF traffic is dropped because there is a mismatch between the mapping in the SAP-egress policy and in the queue-group template.
Correct Answer
verified
Multiple Choice
A) All untagged frames will be forwarded to VPLS 1.
B) All frames with more than one VLAN tag will be dropped.
C) A frame with an outer VLAN tag of 300 and inner VLAN tag of 100 will be forwarded to VPLS 2.
D) A frame with a single VLAN tag of 500 will be forwarded to VPLS 1.
E) A frame with an outer VLAN tag of 500 and inner VLAN tag of 300 will be forwarded to VPLS 3.
Correct Answer
verified
Multiple Choice
A) In the CSC VPRN, configure an eBGP session between CSC-PE and CSC-CE and use the CLI command "advertise-label vpn-ipv4" to enable the advertisement of VPN-IPv4 routes.
B) When the customer carrier uses the same autonomous system number in various sites, use the CLI command "loop-detect off" to disable the loop detection functionality on CSC-CE and PE routers.
C) On the CS?-PE routers, use the CLI command "carrier-carrier-vpn" to configure the VPRN service as CSC.
D) Configure an iBGP session between PE1 and PE2 and use the CLI command "family vpn-ipv4" to directly exchange end-customer routes learned from CE1 and CE2.
Correct Answer
verified
Multiple Choice
A) MP-iBGP sessions must be configured between the PE routers in each AS.
B) LDP must be configured in each AS.
C) MP-eBGP sessions must be configured between the ASBRs.
D) The ASBRs must be configured with "enable-inter-as-vpn".
Correct Answer
verified
Multiple Choice
A) Bridge B 1/1/3
B) Bridge B 1/1/2
C) Bridge D 1/1/1
D) Bridge D 1/1/3
E) Bridge E 1/1/1
F) Bridge E 1/1/3
Correct Answer
verified
Multiple Choice
A) An MP-BGP update carries an MPLS label that is used as the service label for a VPRN.
B) There can be multiple Route Targets per route in an MP-BGP update.
C) There can only be one Route Distinguisher per route in an MP-BGP update.
D) On a specific PE, the MP-BGP updates for prefixes from a single VPRN carry different labels.
E) Traditional BGP attributes and MP-BGP attributes are present in an MP-BGP update.
Correct Answer
verified
Multiple Choice
A) The router must receive several BGP routes to compute a backup path.
B) BGP FRR can be triggered by BFD.
C) The backup path can use the same next-hop as the primary path.
D) BGP peer-tracking can be used to improve BGP FRR failure detection times.
Correct Answer
verified
Multiple Choice
A) Simplifies signaling.
B) Increases requirement for replication.
C) Increases MDU configuration complexity.
D) Increases the complexity of an inter-domain connectivity solution.
Correct Answer
verified
Multiple Choice
A) "Spoke_Sites"
B) "Hub_Site"
C) "Spoke_Sites" and "Hub_Site"
D) No communities should be imported.
Correct Answer
verified
Multiple Choice
A) PE1 sends an IPv4 update for prefix 192.168.1.0/27 via MP-BGP to ASBR1.
B) ASBR1 sends an IPv4 update for prefix 192.168.1.0/27 ASBR2.
C) ASBR1 transforms an IPv4 update for prefix 192.168.1.0/27 to a VPN-IPv4 route and allocates VPN label V1 and sends the update to ASBR2.
D) ASBR2 accepts a VPN-IPv4 update from ASBR1, then sends the update to PE2 via MP-BGP.
Correct Answer
verified
Multiple Choice
A) show router route-table
B) show router bgp routes
C) show router bgp routes <prefix> hunt
D) show router bgp neighbor <ip-address> received-routes
Correct Answer
verified
Multiple Choice
A) Operates in transparent mode.
B) Inherits SAP and SDP state from uVPLS.
C) Does not carry customer traffic.
D) Runs one instance of RSTP per VPLS.
Correct Answer
verified
Multiple Choice
A) Reduced number of VPN tunnels that need to be managed.
B) Optimal routing between all sites.
C) Limited configuration required on the hub PE device.
D) Site to site redundancy support.
Correct Answer
verified
Showing 21 - 37 of 37
Related Exams